Jump to content
Corsair Community

Bad TwinX 3200 C2PT Module


SaLiVa

Recommended Posts

I rescently purchased CorsairXMS 512MB TwinX3200 C2PT (2X256) and have discovered that one module is bad. Windows would BSOD after awhile. I looked around your forum for help and saw other post related to my A8V-E and tried changing my BIOS settings. This still didnt resolve my probably so I ran Mestest on both stick in single channel mode and discovered one stick was bad. I had nothing but error messages. The other stick is running perfectly. I would like to RMA the bad module.
Link to comment
Share on other sites

What specific BIOS settings did you use? Should've been this:

 

CAS Latency (tCL): 2.5

RAS to CAS Delay (tRCD): 3

Row Precharge (tRP): 3

Active to Precharge Delay (tRAS): 6

 

Memory Voltage: 2.75 Volts

All other settings to defaults.

Link to comment
Share on other sites

Advanced CPU/Memory Configuration:

Memclock Mode: Limit

Memclock Value: 2:1 (DDR400)

Bank Interleaving: 4/Enabled

Burst Length: 8

SDRAM CAS Latency: 2.5T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Active to Precharge Delay (tRAS): 6T

SDRAM Row Precharge (tRP): 3T

2T Command Rate: Disabled

ECC Configuration:

Master ECC Enabled: Disabled

Hypertransport: 5X

Jumper Free/Frequency Voltage Control:

AI Overclock Tuner: Manual

CPU FSB Clock: 200

CPU Multiplier: Auto

CPU Voltage: Auto

DDR Voltage: 2.8 Volts

 

one stick runs fine other one just get endless errors.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...