Jump to content
Corsair Community

Bad 2nd stick of memory


joshr45

Recommended Posts

i just tested my 512x2 sticks of memory CMX512-3200PT and it had 7 errors at the 864.3MB mark with memtest86+ what do i do... the RMA forms says i need some ticket id..

 

 

 

Was crashing my system every 15 mins took it out hasnt crashed in 8 hrs

Link to comment
Share on other sites

CMX512-3200PT motherboard is GA-K8NSNXP processor is AMD athlon 64 +3200 everything in the bios is set at default i dont overclock my hardware

the mhz on the processor was set at 200 and ram was i think at 66 since i would have to shut down to know for sure, i tried checking if the HT had problems with the default setting it was at was at 5x i set it down to 1x didnt make a difference still crashed every 15 mins or so

Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts) and then set the timings to "BY SPD", and then test the module/modules again with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...