genesedn Posted June 21, 2005 Share Posted June 21, 2005 I have a DFI Lanparty NF4 UT SLI-DR board paired up with a 1 GB Value Select Kit from Corsair. I am getting constant blue screens of death, which I have finally isolated to a compatability issue between Corsair and the motherboard. Both seem to be working fine on their own, but not functioning properly together. Your website lists this specific RAM module as being compatible, I don't know what to do next. Are there bios setttings which will remedy this situation. From reading other forums this seems to be a common but not officially recognized issue. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted June 21, 2005 Corsair Employees Share Posted June 21, 2005 Please make sure you have the latest BIOS installed for your MB (download the Beta version) and load optimized defaults settings, and try the following BIOS settings; VS512MB400 or VS1GBKIT400 Genie BIOS/DRAM Configuration DRAM Frequency Set: 2:1 or 400MHz or 200 (if option are 133/166/200) Command per Clock: Disabled SDRAM CAS Latency: 2.5T SDRAM RAS to CAS Delay (tRCD): 3T SDRAM Row Precharge (tRP): 3T SDRAM Active to Precharge Delay (tRAS): 8T And leave the rest at AUTO setting Genie BIOS FSB BUS Frequency: 200 LDT/FSB Frequency ratio: 5X LDT Bus Transfer Width: 16 16 CPU/FSB Frequency ratio: Auto PCI Ex: 100 K8 cool N’ quiet: Disable CPU VID Start Up Value: Startup CPU VID Control: Startup CPU VID Special Control: Auto Chipset Voltage Control: 1.6 DRAM Voltage Control: 2.8 PC Health Status: Please change all temperature at 25C All other settings are motherboards defaults Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.