I cant control my XD7 pump/res

[Nissehult]

Hey, i have a 5000T and and having custom water cooling, having a commander xt core, i can control my rgb on XD7 and XC7RGB PRO CPU block.
when i open ICUE i cant find commander xt core and i cant do a run wizard on hydro X products i have in my pc so i cant control the pump at all.

[Nissehult]

[c-attack]

When you connect the special case lighting to the ID port on the Commander XT it puts that device into "case mode", the same way the Elite Capellix models put their Commander Core into AIO mode when connected.  Your pump is on Fan header #6 and you should be able to create a custom control curve for it using the yellow + button.  You are not required to use the Hydro X presets and like all presets they are someone else's curve.  Most users will want to create their own since each water cooling set up is unique.  

[Nissehult]

i like the hydro x presets, then i dont need to care to make own curve

[Nissehult]

is there anyway to put the case mode off?

Edited February 3 by Nissehult

[Corsair Notepad]

You would then lose control over the case specific lighting

[LeDoyen]

4 hours ago, Nissehult said:

i like the hydro x presets, then i dont need to care to make own curve

You can tune it later if you want. The default curves are pretty terrible but you'll see as you use the beast if it runs too warm or if it's too noisy despite running cool.

The hydroX wizard does not know how many radiators you have or how powerful the components are, so, the default fan curves are really a shot in the dark. Often misses the point.