Jump to content
Corsair Community

TWINX set may be mismatched factory set?


Fiat1

Recommended Posts

TWINX set may be mismatched factory set?

 

Ram Guy:

I purchased a set of TWINX CM512-3200C2 a while back. Just recreantly I have upgraded my mother board to an ASUS A8N DELUXE. I also have just now used CPU-Z and I have noticed that it shows that the memory is missed matched. CPU-Z shows the following

Module 0

Corsair DDR-SDRAM PC3700 - 512 MBytes

Module 1

Corsair DDR-SDRAM PC3200 - 512 MBytes

But both sticks read as follows.

CMX512-3200C2 XMS3202V1.2

0351024

XMS 3200 512MB 400MHZ CL2

 

What can I do to RMA them and get a matched set? I can send a photo to you or I will try and host it.

 

Fiat

 

Thanks

Link to comment
Share on other sites

  • Corsair Employees

Please make sure that you have the latest BIOS for your MB and load Setup/optimized default settings, and try the following BIOS settings;

TwinX1024 or TwinX512-3200C2

Advanced/Jumper Free

AI over clocking: Manual

CPU Freq: 200

Memory or Dim Reference voltage: 2.75 Volts

System performance: Standard

Advanced/CPU/Memory or DRAM Configuration

Memclock Model: Limit

Memclock value/ratio: DDR 400MHz

SDRAM CAS Latency: 2.5T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Row Precharge (tRP): 3T

SDRAM Active to Precharge Delay (tRAS): 6T

SDRAM Burst Length: 8

1T/2T Memory Timing: Auto or 1T

All other settings should be set to default settings!

Then please test them one at a time with http://www.memtest.org and let’s make sure it's not some other issue! I would run the test for at least 2-3 passes to be sure!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...