Jump to content
Corsair Community

Bad Module? CMX512-3200XLPRO x 2


Recommended Posts

I purchased 1 GB Corsair CMX512-3200XLPRO memory from NewEgg.com. I have never been able to run both modules in dual channel mode. I have a DFI Lanparty NF4 Ultra-D motherboard, and this board requires the modules to be in DIMM 2 & 4 to run in dual channel mode. If I place the 2 modules in DIMM 1 & 2, I can boot my PC, however this is in single channel mode.

 

I ran the test from MemTest and encountered thousands of errors. Just yesterday I booted my PC, only this time I received the blue screen of death and have since not been able to load WinXP. The only thing I can get to is my BIOS settings. All BIOS settings are currently at their default values. I have made this post before, roughly 2 months ago, followed all the advice given to me by RAM Guy (changing all voltage and latency settings etc.), and to no avail never was able to fix the problem.

 

Now my PC is dead in the water and I would greatly appreciate the opportunity to return these modules.

 

SOS! Thanks!

-Joe Anthony

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...