Lighting node question

[e90_wes]

Hi all! Looking for more information as to what I need to get so I can sync all the rgb on 18-20 ql 120 fans. All of the fans were bought as a 3 pack so I do have the control boxes that came with them. Will I need to get the pro node or can I just chain all the controllers that came with the fans and achieve the same result? Any info is greatly appreciated, thanks in advance!

[DevBiker]

For 20 QL fans, you'll need at least 4 Lighting Node Cores (6 fans each).

You'd be best served getting an internal USB hub if you want to use the LNC's that you have.

[e90_wes]

Thanks for the reply! I was looking into a USB 2.0 splitter and two 10x fan hubs. I know going this route means they all spin at the same speed which is fine. I do have that many LNC's but I was curious about if I do plug them into the same splitter they will all run the same light pattern instead of going in sequence, correct?

Edited September 18, 2021 by e90_wes
Spelling correction

[DevBiker]

First, you do not want a USB splitter. They are unpowered and will give you grief. Get a powered USB hub - the NZXT one is frequently used.

Now, when you connect the LNC's to the USB hub, each one will be a separate device in iCUE. So you'll be able to configure each one separately.

[e90_wes]

Thats exactly the info I was looking for! Thank you so much!! I'll be ordering the nzxt powered hub today. I'll make sure to return and post a pic of the finished product. Still waiting on some ek parts and a couple other little things.