Jump to content
Corsair Community

Disable Zero RPM Mode on H115i Pro?


DanielDC88
 Share

Recommended Posts

The noise of the cooler trying to start my noctua fans from 0RPM is really annoying, and at their lowest speed the fans are inaudible over even the pump. I'd like to stop the fans going to 0RPM, but the software only works in percent.

 

How do I configure this?

 

Thanks!

Link to comment
Share on other sites

It should not be using zero rpm mode unless you specifically set the fans to run it.  The Quiet preset would be a better choice, but the best is to hit the + to create a custom curve, then select the concave shape tool (2nd from the left).  This is the Quiet preset, but now you can see the points and adjust them.  You can pull the baseline line speed down to the fan minimum and round off the top end if needed.  Make sure the sensor is set to H115i Pro Temp (coolant temperature).  

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...