Jump to content
Corsair Community

H80i v2 with MSI B650 (LGA 1200)


Recommended Posts

Hi. First time building since 2005 so I'm pretty sure I'm missing something obvious.

 

The intel backplate fits the hole pattern, but the threaded sockets (backplate pins?) sit proud of the circuit board, so when I tighten the standoff screws the backplate is not firm against the board. There is about 1-2mm of play.

 

A washer on each would fix this but there are none included. I can go and buy some but I'd like to know first if I am doing something wrong here. I don't imagine that the motherboard itself is thinner than other boards, so this should be workable without modifying anything.

 

I've attached a picture.

The mobo is MSI MAG B560 Torpedo, LGA 1200.

1689951794_corsairH80ibackplatepinsstandingproud.thumb.jpg.d8cea3fe24f3036977930152e3bcf37e.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...