4000X fan setup

[Xr3iRacer]

Hi

 

I have the 4000x case and i plugged the three fans from the case into the motherboard for power and the rgb into the lighting node that came with the case. I installed a H100i Elite Capellix in the top and that came with a commander controller, should i have put the case fans into this for power and RGB? Or do the case fans need to plugged into the motherboard so there speed can be set with the cpu temp?

 

Many thanks

[baz2011uk]

plug them into the commander core as this will run 6 x fans

and remove the node unless you use more than 6 fans

i have the same

3 x front fans

h100i elite capellix

1 x rear

 

all running from the commander core

 

i know my cable management is not great but this give you the idea

[Xr3iRacer]

Thanks thats great. Im assuming you can then control fan speed yourself as opposed to the front fans spinning up everytime the temps shoots up and down?

Do you custom curves on your cooler?

[baz2011uk]

it depends on the fans i did swap all mine out to ql's and have full fan control either custom or pre sets

[baz2011uk]

and with a user name XR3I you know you need to post a pic up of your motor

last decent xr3i i seen was a Cadburys purple one back in MK in the 90's was very nice

[Xr3iRacer]

Haha, yeah it was a great old car. Thanks for your response. Its looking like my AIO cooler is going for replacement so i will try it all then. A