Jump to content
Corsair Community

Question about Commander Pro notifications


BlaiseP

Recommended Posts

Firstly; regarding the Commander Pro, I know that the pre-built fan curves (Quiet, Balanced & Extreme) are based off the CPU die temperature as a source. However, with a notification event entry where I have a water cooling 10kΩ temperature probe connected to one of the temperature sensor ports, does (or can) the sensor's temperature threshold be used to trigger a notification event?

 

I suspect the answer to be that all notifications are hard-coded to be triggered by a CPU die temperature threshold as you cannot set the input temperature source for notification event. If it is possible - good but if not, could this be added as feature request?

Link to comment
Share on other sites

I don't see a way to select the temperature source either. Must be why I don't ever use them.

 

It really would be helpful if the temp probes could be one of a series of selectable sources. There are a lot of users with the Commander Pro as the control center of their custom water cooling. Being able to use water temp as a trigger (just like the AIOs) would be useful.

Link to comment
Share on other sites

So it seems this is already there, but hiding in plain sight. Like some of the other CUE 3 features, it is applied in a slightly different way.

 

1) Create your notification (+) and set what ever action you prefer.

2) Then click on any combination of the 4 temp sensors above. Any of them selected can trigger the alter. When ringed yellow they are active.

 

 

tvy6kue7oo3dil06g.jpg

Link to comment
Share on other sites

×
×
  • Create New...