Mannekino Posted December 29, 2020 Share Posted December 29, 2020 Can I use the pre-applied sticky tape of the RGB Fan LED Hub to stick that to the front of a Commander Pro or will that cause signal/heating issues? I would like to stack these two parts so it's basically one unit for easy cable routing. This would be my perfect solution since I have a lot of cables to manage in my build. Thanks. Link to comment Share on other sites More sharing options...
c-attack Posted December 30, 2020 Share Posted December 30, 2020 (edited) You can probably can stack them. However, be aware the Commander Pro gets a bit hot in the middle. I don't think it will affect the RGB Hub. It might make the Commander a little worse off. This is 25C ambient and a high airflow case will lots of surrounding space. Best possible thermal situation, aside from direct cooling. Not sure how the adhesive will hold up. However, this should also give you a target and the spot to avoid. Edited December 30, 2020 by c-attack Link to comment Share on other sites More sharing options...
Mannekino Posted December 30, 2020 Author Share Posted December 30, 2020 Thank you. That's very interesting. Link to comment Share on other sites More sharing options...
Recommended Posts