Jump to content
Corsair Community

how to make memory not flicker, what are the right settins


mfalske
 Share

Recommended Posts

i have a 2x8 corsair rgb pro, i have it set to the custom wave settings with 7 colors. i am trying to figure out the tail and velocity along with lights per second. every configuration, after it cycles the rgb flickers and then resets. does anyone know the right settings for this?

713263909_Screenshot(4).thumb.png.85a9acb48848234b6b5ae5f35407808a.png

Link to comment
Share on other sites

Your lighting time is too low. At 3 seconds, it will only advance 2.0 LEDs/sec according your instruction. So it would go about 3/4 of the way and then it would start over again. Try 7 seconds for total lighting time (for 2 LED/s and tail 5). You can then add another 1-2 seconds if you want a pause in between the finish and re-start of the wave.
Link to comment
Share on other sites

 Share

×
×
  • Create New...