ChibChombo Posted September 27, 2020 Share Posted September 27, 2020 Hello, So I have 9 of the new EK D-RGB Fans for my new build, I will be using 2 Commander Pro's to control their speed through iCue, but I would also like to control their RGB. They connect through 3 PIN to Motherboard D-RGB port, I know Corsair uses 4 Pins on the Fan RGB Hub, but I was able to find some cables on E-Bay that allow me to connect the 3 PIN of the Fan to a connector that can plug on the Commander Pro OR the Lighting Node Pro led channels, but I don't know if these channels would be good to connect fans to? Would this option even work? Or what would be the best way if possible? Thank you. Link to comment Share on other sites More sharing options...
LeDoyen Posted September 27, 2020 Share Posted September 27, 2020 Check out this thread, might help : https://forum.corsair.com/v3/showthread.php?t=200148 Link to comment Share on other sites More sharing options...
ChibChombo Posted September 27, 2020 Author Share Posted September 27, 2020 Oh nice, that explains a lot! But also left me a little confused; How would I run 9 Fans off of a Commander Pro and a Lighting Node Pro? I think he shows that an RGB Fan Hub works if you have a corsair product plugged into it, but I don't have a corsair product. So I think I'd have to use the other 2 options. But the Commader Pro and Lighting Node Pro only have 2 LED Ports each, not sure if I would be able to run splitters to power all the 9 fans? Thank you! Link to comment Share on other sites More sharing options...
Recommended Posts