iightfyre Posted September 12, 2020 Share Posted September 12, 2020 Hi again Corsair Peeps! So, before I mount and install everything - should I flush the Corsair rads and water blocks? Corsair manual says no, internet videos say yes. Any advice? Thanks in advance as always!! Link to comment Share on other sites More sharing options...
iightfyre Posted September 12, 2020 Author Share Posted September 12, 2020 Edit - new rig. Rads and water blocks and tubing and fitting new in box Link to comment Share on other sites More sharing options...
iightfyre Posted September 12, 2020 Author Share Posted September 12, 2020 Thanks! I saw a vid by ekwb says hot water and vinegar then flush with just distilled after that. Is that the best way? Link to comment Share on other sites More sharing options...
Zotty Posted September 12, 2020 Share Posted September 12, 2020 no need to flush Corsairs rads/blocks..... i did so with mine and they was totally clear. others in my Discord server have found the same... Link to comment Share on other sites More sharing options...
iightfyre Posted September 12, 2020 Author Share Posted September 12, 2020 Thanks! Much appreciated Link to comment Share on other sites More sharing options...
LeDoyen Posted September 12, 2020 Share Posted September 12, 2020 rads that are sold as "clean, no flushing needed" won't give you big weld flux or copper bits in the loop, but you'll always find small dust and particulates with time. So you may flush them if you like but they shouldn't be any big deal. doesn't hurt to rinse them anyway :) it takes a minute. Link to comment Share on other sites More sharing options...
Recommended Posts