Space_Viking114 Posted August 30, 2020 Share Posted August 30, 2020 So I finally finsished assembling my new computer tonight and this is the first time I've added RGB fans. I had a topic in the Cooling board and I thought I followed everything correct but the lighting is not acting how I think it should. I've attached a couple pictures that I think should help explain it. I've tried to change colors to match but the only things I can change are the things that are light blue (motherboard, AIO, and 1 fan on the AIO) I have an h100i and a Commander Pro with a Lighting Node Core attached to it. First off, ALL the fans are spinnging so that is awesome. As far as the h100i goes, ONE fan is not lit up. I changed the fan connections and the other fan began to light up while the other one stopped. I'm using the two connectors coming off the h100i. Long story short - The AIO and one fan are working as far as lighting goes. It's connected via a sata cable that has 4 sata connectors on it, all in use. The 6 other fans are all spinning but stuck on the Rainbow Wave setting. I can select other patterns and colors and it reflects in the software but not on the actual fans. Those 6 have the RGB cables connected to a Lighting Node Core connect to the Commander Pro via the USB area. I've read some guides, tried new profiles, nothing is working. Any suggestions? Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted September 2, 2020 Corsair Employee Share Posted September 2, 2020 Double check your connection between the lighting node core and the commander pro. it's possible you might have plugged in the usb cable incorrectly (you could also try swapping ports on the commander pro usb hub to see if the lighting node core is detected). Link to comment Share on other sites More sharing options...
Recommended Posts