Jump to content
Corsair Community

Help setting up additional SP120 fan


KosTheory
 Share

Recommended Posts

I recently bought a 220T case that came with 3 SP120s and bought 1 more to go in the back of the case. This case came with a Lighting Node Core preinstalled with the fans already hooked up to ports 1-3.

 

I bought a Commander Pro as well and have the 3 factory fans plugged into 1-3 on both the Commander Pro and Node, and they all work fine. However, the additional fan (pin 4 in both the pro and node) that I bought will spin, but not light up. I initially thought the fan's LEDs were the problem, but I am now having the same issue with another fan.

 

My Node in iCUE is set to SP RGB PRO Series Fans, 4 Fans.

 

I've gone through the Support pages but could not find anything to help.

 

I've been messing with this for about two weeks and any help would be much appreciated.

Link to comment
Share on other sites

Well ... port #4 on the Lighting Node Core. And it is.

What happens if you swap the fans on Port 3 and Port 4?

Also, are you positive that you got SP-PRO and not plain SP-RGB? Can you verify the part number on the rear sticker of the fan?

Link to comment
Share on other sites

Well ... port #4 on the Lighting Node Core. And it is.

What happens if you swap the fans on Port 3 and Port 4?

Also, are you positive that you got SP-PRO and not plain SP-RGB? Can you verify the part number on the rear sticker of the fan?

 

The ebay post I bought it on listed it as a Pro, but I have now confirmed it is not. *facepalm*

 

Thank you so much for the help

Link to comment
Share on other sites

 Share

×
×
  • Create New...