Jump to content
Corsair Community

Corsair H100x - Broken! :(


C4live
 Share

Recommended Posts

Hello, I recently bought a new Corsair H100X, installed it and everything was ok, the other day I had to reinstall the cooler on my new Phanteks case P600S, everything was going fine...when installing the last screw of the cooler it simply snaped...and broke the screw..! Belive it or not...I didn't do any abnormal or excessive amount of force...:confused:

 

Has this happened to anyone?

 

I contacted the customer service but didn't receive any answer until now :(

 

Best Regards

Diego

Link to comment
Share on other sites

Was the orientation of the waterblock causing too much force to applied to break? An good luck on feed back from Corsair, it takes a littler over a week for me to get a response. It does indicate on their website i believe that response times are longer than usual given everything thats going on.
Link to comment
Share on other sites

Was the orientation of the waterblock causing too much force to applied to break? An good luck on feed back from Corsair, it takes a littler over a week for me to get a response. It does indicate on their website i believe that response times are longer than usual given everything thats going on.

 

It was all installed using the instructions on the manual :(

 

Yeah haven't heard from them...this is very bad customer support! :evil:

Link to comment
Share on other sites

 Share

×
×
  • Create New...