Jump to content
Corsair Community

Connecting Lian Li Strimer Plus + Lancool II-2x to Lightning Node Pro


Erebus91
 Share

Recommended Posts

Hello,

 

i was wondering how you can connect the Lian Li Strimer (both the 24 and 8 pin version) and the Lancool II-2x with a Lightning Node Pro and a Commander Pro.

One rgb channel on the lightning node pro supports up to 60 LEDs but the Strimer has 120 LEDs on the 24-pin, 108 LEDs on the 8-pin verison and 37 LEDs on the II-2X.

 

Since the Lightning Node Pro has 2 channels means 1 Node supports up to 120 LEDS.

 

Does this mean not all LEDs are supported if i only connect one channel with the Strimer? Do I need multiple Nodes? :confused:

 

How do I connect the Strimer/II-2X with the Node(s) that iCUE addresses all of the LEDs in the correct order? :question::question::question:

 

In addition to that I would like to connect 5 Corsair iCUE Fans and the 3 ARGB parts of the Scythe Mugen 5 ARGB Plus.

 

That's a lot of RGB.

:eyebuldge

 

I already saw this post https://forum.corsair.com/v3/showthread.php?t=173880&t=173880 which was already really helpful but not all questions are cleared up for me.

 

I would really appreciate your help community! :newbie:

Link to comment
Share on other sites

  • 5 months later...

Hello,

 

So you will need a 10$ adapter to connect the Lian Li STRIMER plus to the Commander pro or Lightning Node (I tested on both and both works). (https://www.ebay.com/itm/372521827376)

 

Once it is done, press M1 on the Strimer Plus Controller for a couple seconds to activate Motherboard mode (it also works with Icue, not just motherboards RGB like AURA, etc).

 

Once all that is done, go to Icue and select the channel of the Strimer. You can configure it as RGB Strips or even fans. I've tested both and it works.

 

Enjoy

Edited by Terence91
Link to comment
Share on other sites

  • 2 weeks later...
 Share

×
×
  • Create New...