MorrisHuts0n Posted June 12, 2020 Share Posted June 12, 2020 Hey, I'm new on forum so if it is wrong place to ask my question I'm sorry! I just bought a new LL120 Single white fan for my case's backside, I connect it's RGB cable to my motherboard's JRGB2 pin and when I tried to control it's RGB LEDs from iCue, the software cannot detect my fan. Also, I tried it from MSI Dragon Center software, when I started to change my motherboard's RGB LEDs; my fan only shows Red LEDs inside it. I cannot see any of the other colors. Can anyone help me, please? (I don't have lighting node pro). Link to comment Share on other sites More sharing options...
MorrisHuts0n Posted June 12, 2020 Author Share Posted June 12, 2020 https://prnt.sc/syixxz This is the maximum color that I can take from my fan if I set to motherboard's color to a different color from Red, Yellow and Orange. Link to comment Share on other sites More sharing options...
c-attack Posted June 12, 2020 Share Posted June 12, 2020 Unless your MB has a MSI specific "JCorsair" header (which it appears you do not), then you need a lighting controller and lighting power supply like everyone else. Hopefully those are 5v RGB headers you are connected or fan damage is likely. The specs page for your motherboard does not specify. There is more in this guide, but it's a tough sell for one fan. Link to comment Share on other sites More sharing options...
MorrisHuts0n Posted June 12, 2020 Author Share Posted June 12, 2020 Thank you so much for your feedback Link to comment Share on other sites More sharing options...
Recommended Posts