Jump to content
Corsair Community

Hydro X LED issues


Declare4
 Share

Recommended Posts

Hey everyone,

 

Today I updated my watercooling loop, I have had the hydro X softtubing loop for about a year and noticed the tubing was a getting a bit yellow and it was time to replace and update.

 

I drained the system and everything seems to working well and looking nice.

 

However, I noticed an issue with my Hydro X GPU block the LED are not turning on as well as about 4 LED on the pump/res combo. In the iCUE software they are registered and show as functional. I have made sure everything is plugged in and everything seems to be in order however my GPU block has no LED and my pump/res has only a few.

 

Any ideas or suggestions??

Link to comment
Share on other sites

It seems like there is a break on the pump/res strip and since the GPU is (presumably) after that further down the chain, it is out too. You can probably verify the gpu is OK by plugging it directly into the controller without the Pump/res.

 

As for that, contact Corsair Support through the ticket system. They have a special group for hydro x. Hopefully that can be resolved by a simple strip replacement.

Link to comment
Share on other sites

 Share

×
×
  • Create New...