Jump to content
Corsair Community

Abit KV8 Pro & 2x512 XMS3200


Moley

Recommended Posts

Hello All,

Got a bit of a Headache going on at the moment. Have just built the following :

 

Abit KV8 Pro

AMD 64 3400

2x512 XMS3200

 

For some reason my system will not let the 2 work togther. Either 512 works in a single bank but the system only registers 512 when they are in togther ?

 

Ram1 =

CMX512 3200C2PT

XMS3202V1.5

0512147-0

CL2

 

Ram2 =

CMX512 3200C2PT

XMS3202V4.2

0510085-2

CL2

 

If any one could shed some light on the issue I would be most appricated !

Thx

Link to comment
Share on other sites

Hello Moley!

 

1) The v5.1 module will only run CAS 2.5-3-3-6 on an AMD system and thus you'll have to run both modules at that rate.

 

2) You're mixing module revisions which could cause problems.

 

However, it's kind of a wierd thing to come up like that... have you tried running only one module in each of the mainboard's memory slots? Maybe you have a bad DIMM slot and the modules have nothing to do with it!

 

PLUR

CK

Link to comment
Share on other sites

Can any one help ? How do I change the settings so I can get them to work together or is it possiable to send them back and get two that are the same ver ?

 

I dont really want to shell out another £100 gbp if possiable :)

Link to comment
Share on other sites

Hello All

Got a bit of a Headache going on at the moment. Have just built the following:

 

Abit KV8 Pro

AMD 64 3400

2x512 XMS3200

 

For some reason my system will not let the 2 work together. Either 512 works in a single bank but the system only registers 512 when they are in together?

 

Ram1 =

CMX512 3200C2PT

XMS3202V1.5

0512147-0

CL2

 

Ram2 =

CMX512 3200C2PT

XMS3202V4.2

0510085-2

CL2

 

If any one could shed some light on the issue I would be most appreciated!

Thx

Link to comment
Share on other sites

  • Corsair Employees

Dim Voltage to +2.7 Volts:

CAS Latency CL=2.5

Row Cycle Time tRC Bios Default

Row Refresh Cyc Time tRFC Bios Default

Ras# to CAS# delay tRCD 3

Row to Row delay Bios Default

Min Ras# Active Time tRAS 7

Row Precharge Time tRP 3

Write Recovery Time Bios Default

Write to Read delay Bios Default

Read to Write Delay Bios Default

Refresh Period tREF Bios Default

Enable 2T Timing Enabled

Then test the system with http://www.memtest.org and make sure it's stable!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...