Jump to content
Corsair Community

Corsair One Pro Fans in bios


inkydink
 Share

Recommended Posts

Hi. I recently got a Corsair one Pro (Intel i7-7700K,GTX 1080) and it overheated during stress test (75-80 degrees). When I entered bios to reset it, I noticed in bios that only one fan was on. The other fan does not spin (0 RPM). I tried to change the temperature curves to see if I can get it to turn on but it does not. The 'CPU Fan' spins at around 4300RPM, but the 'System Fan' is not spinning or 0 RPM.

I was wondering if this is normal and the Video Card is broken or if there is something preventing the fan from turning on. I'm assuming that 'System Fan' is the fan mounted on the Video Card?

Please let me know if anyone has any info on the two fans in the system and how to check if they are working

Thanks

1498083197_corsaironebios.thumb.jpg.53f60a02d63a8e32604309c459a7589e.jpg

Link to comment
Share on other sites

Hi. Thanks for responding. I could only install Corsair Link 4.4.3.15 since the download of the other versions were for other Corsair one's and they refused to install. I purchased it used. I think its the Video Card as the Video Card is overheating up to 75 Degrees. I know the pumps and the fan(s?) are increasing in speed but the temperature still overheats. I will try to get another video card to replace it.

I did try to remove the video card. Do you know how to remove it? I managed to disconnect everything but the card would only pivot. Does this mean I need to remove the motherboard to unscrew something from the Motherboard side? I'll post a new question in the forums but I wanted to see if you knew how to remove it.

If there's any other possible reason for the video card to overheat, please let me know. I do perform stress test but instead of aborting or decreasing performance, the video card just goes to over 75 degrees and the system freezes and restarts. I thought computers had some protection against that.

Thanks again.

Link to comment
Share on other sites

FYI if this is for your GPU I contacted corsair because I noticed the same thing. and they said it was made that way for the liquid cooling. ( the one fan not spinning) atleast for the 2080 ti. I am not impressed with the overall cooling of the system and its quite upsetting
Link to comment
Share on other sites

 Share

×
×
  • Create New...