Jump to content
Corsair Community

Cannot control H115i RGB Platiunum Pump


kodath
 Share

Recommended Posts

Hi all,

 

I just installed my new H115i RGB Platiunum and everything seems to be working except I cannot control the pump.

 

It appears to be stuck in Balance Mode.

 

I have uploaded some images here: https://imgur.com/a/yWrqDlX

 

Also it appears that Corsair Link is not detecting the H115i.

 

I have tried the troubleshooting steps found here under A1: https://forum.corsair.com/v3/showthread.php?t=174442&t=174442

 

But nothing seems to work, when I swap in my old H100, Link is able to detect it.

 

Any ideas?

 

Thanks!

Link to comment
Share on other sites

The Platinum coolers came out 18 months after the Link program was replaced with iCUE. It will not detect the cooler. There is no reason to run Link unless you have one of the two or three legacy devices that require it.

 

In your photos, you have not applied the speed setting to the pump. First click the preset (quiet/balanced/extreme). Then click on the pump speed (rpm). It will ring yellow and the descriptor will change.

Link to comment
Share on other sites

 Share

×
×
  • Create New...