Jump to content
Corsair Community

500D SE Cooler/Fan question please


Tom899
 Share

Recommended Posts

I'm getting ready to order parts and could use some help please. I have been reading the forum a lot and also the QA. I just want to be sure.

I'm ordering a Obsidian Series 500D RGB SE.

I want either a H115i Platinum or H150i Pro mounted in the front and decided for push/pull. This will be for an AMD 3900x. Not sure if I should get the H115i or the H150i??

But either way, I also need to order the correct two fans for the top and one for the back. I heard the included fans that come with the cooler should be plugged into the cooler? and all the other ones into the Commander PRO?

If this sounds correct, what are the exact fans I should purchase for the top and back?

Thanks,

Tom

Edited by Tom899
Link to comment
Share on other sites

Hey Buddy.. Yeah you seem to be heading in the right direction... imho go with the H150i.. suits the the 500D se well.. and push/pull looks so good in it and as you get LL fans with the case then it makes sense to stick with LL's imho

Thanks Zotty, I'll budget for the H150i then. And, I'll get the LL fans for the top and back. I assume it's OK to use the fans that come with the H150i in my push/pull config. So, I'll have the case LL fans pushing, and H150i fans pulling. Any other controllers or hardware I need other than what comes with the 500d SE?

Thanks,

Tom

Link to comment
Share on other sites

 Share

×
×
  • Create New...