Jump to content
Corsair Community

Slot 6 for hydro pump just dissappered


streetglider
 Share

Recommended Posts

So I woke my computer up and noticed it took longer foe the pump to start mind you this is my second one so I put a l flow indicator in this time. It started spinning and I went into icue to check to see if anything was wrong and now the slot 6 is missing where its plugged into, I just had problem the about 4 days ago the pump would not go over 800 rpm with I cue and icue wouldn't make it change. I let the computer shut down and sit for and hr and has been fine. its spinning right now but not able to see it to control it.
Link to comment
Share on other sites

they have always been set on auto and have been viable and working just fine. I finally just turned computer off and let it set again and it just magically reappeared. I went ahead and set them to 4 pin in hoping that this wont happen again. my fear was my

commander pro was going out.

Link to comment
Share on other sites

 Share

×
×
  • Create New...