Jump to content
Corsair Community

Corsair Obsidian Series 1000D CC-9011148-WW Super Tower


belezeebub
 Share

Recommended Posts

I wasn't planning on changing my case but I found out today that the Motherboard I want is XL-ATX Form Factor; 32.5cm x 27.5cm

Before I plop down for a 1000d can anyone tell me if it supports this new form factor I can find very few cases listing XL-ATX, I tried contact Thermaltake because I currently have "The Tower 900" but as normal for Thermaltake I get most answers asking any blank wall.

Link to comment
Share on other sites

  • Corsair Employees

Hello,

 

The board will fit in 1000D.

 

you could saw some restriction or limitation depending of the board you'll use :

 

The full XL-ATX (345*262) have extra screw in lower part, they can't be screw on 1000D

 

It could block the possiblity to use the second ITX MB tray.

Link to comment
Share on other sites

  • 2 months later...
I wasn't planning on changing my case but I found out today that the Motherboard I want is XL-ATX Form Factor; 32.5cm x 27.5cm

Before I plop down for a 1000d can anyone tell me if it supports this new form factor I can find very few cases listing XL-ATX.

 

Did you ever do this build? I'm looking at using an XL-ATX TRX40 motherboard, but am concerned about motherboard stability/flex, as well as ITX system spacing. I'm looking at the TRX40 Aorus Extreme.

Link to comment
Share on other sites

 Share

×
×
  • Create New...