Jump to content
Corsair Community

Commander Pro and bits power Bitspower Temperature Sensor Plug


thinkflight
 Share

Recommended Posts

Question for you guys,

 

I've got my rig set up and working wonderfully. I'll be switching video cards to a 2080 ti on water within a month. When I do this I have to drain the loop. So.... I was contemplating adding a Bitspower G 1/4" Temperature Sensor Plug Fitting with O-Ring into the bottom of my EK-RES X3 250 reservoir.

 

Question - will the Bitspower G 1/4" Temperature Sensor Plug work on/with the temperature senor input for the corsair commander pro? I'm not sure if the commander pro uses standard temp sensors or if they are proprietary?

FMI; link to the sensor

 

I'd love to know the water temp compared to all the other metrics I'm gathering.

 

------------------If your curious here is the build-- --------------

Threadripper 1950x @ 4.0ghz all core with a EK full cover mono-block (vrm cooled too) using a custom single loop /w 3 rads (2x360mm ek slim and one 280mm x 45mm EK), 9 corsair ML fans (6x360mm, 3x140mm) duel d5 inline pumps and a 250 x3 reservoir; 1800ML coolant for the system. All in a Thermaltake View 71 case (sorry corsair; your crystal case couldn't fit it all which makes me sad ... needed a little more room for the rez and cabling.)

 

Best part with these fans - when the entire system is maxed (including GPU which is a Vega Frontier air cooled for now till the switch) the MAX DBa output from the chair is only 41dba - Maxed CPU only 34 dba (so i'll get a LOT quieter when i add the 2080ti on water in - looking forward to it).

IMG_0077.thumb.jpeg.48b4585ef1256ecc7505e64d4752d0c4.jpeg

IMG_0078.thumb.jpeg.00688cbd16908787ffb6d37099326408.jpeg

Edited by thinkflight
added link to the bitspower sensor
Link to comment
Share on other sites

 Share

×
×
  • Create New...