Jump to content
Corsair Community

RBG Fans wont link with iCue on Spec DELTA RGB


Tomc611
 Share

Recommended Posts

I have a Spec DELTA - RGB case with 3 RBG fans, a Corsair H100i cooling / fan system inside also, connected to a Aorus Z390 Pro but the case RGB fans are not showing on iCUE and as such will not change colour at all. They are just stuck on orange.

 

Any ideas for help?

 

Thanks

Link to comment
Share on other sites

  • 10 months later...

The Motherboards own RGB software controls it. Each one is specific.

But I got A problem Mine exact same case is having an issue with changing colors the bottom fan will be a different color even though they are daisy chained to one 12v rgb header on my MSI Tomahawk b450 board

I can only use red.

Edited by CptKidd710
Link to comment
Share on other sites

very likely to be a bad connexion but it's easier to troubleshoot than ARGB.

you have one pin for 12V and one pin for each primary color. if you can only set that fan to red, it is most likely not receiving signal for the two other colors.

Check you didn't plug this one backwards too.

Link to comment
Share on other sites

 Share

×
×
  • Create New...