Jump to content
Corsair Community

680X rev2 needed


Dango
 Share

Recommended Posts

I think there is a need for rev2 on the 680X case. It a really nice. However, the is a issue with 280mm radiator compatibility.

 

Although, it said it will fit 280mm radiator on both to and bottom, but it's not possible to make both fit at the same time without remove all fan in the front. There just no enough room for the tubing to come out. One side block by the PCIe slot, the other side is blocked by the front fan. If the radiator/fan mount move 1cm closer to the side window, there will be enough room to rout the tubing behind the radiator fans on the motherboard side. OR shift the mount either forward or back ward for 2cm to give room for the tubing.

Link to comment
Share on other sites

 Share

×
×
  • Create New...