icsim Posted July 24, 2019 Share Posted July 24, 2019 Hello all. A couple of quick questions. I removed my 2nd dead Enermax TR cooler and decided to purchase the H150iPro RGB for my system. My motherboard is a Asus Zenith Extreme latest BIOS 1901, AMD Theadripper 1950X. With the old Enermax my idle temps were around 35C. With the new install I used Thermal Grizzly Grease and install the new H150i after receiving the Corsair TR4 bracket. All looked well for the physical installation. Upon booting I am see temps in Ryzen Master and other monitoring apps of around 68C. I did install the Link software but the Link software stated to use the iCue software. The temp in the software is showing 33.40C? I have tried all the profiles including extreme. Is the 33.40C temp the CPU temp or the water block temp? Is there something I am missing? The fans in thew extreme profile have a speed of around 1575rpm and the Pump 2760 RMP. Thanks for your input! Link to comment Share on other sites More sharing options...
c-attack Posted July 25, 2019 Share Posted July 25, 2019 Do you mean peak temps of 68C or idle??? If idle, then you are not making good physical contact between the block and CPU. H150i Temp is coolant temperature and represents the minimum possible CPU temperature with zero voltage. The difference between the coolant and your peak CPU temperature is the voltage differential or the heat create at the socket. Coolant temperature typically rides about 4-7C above your room temps, but there is definitely case and set-up variations. 16 cores will have more heat at idle than somebody's 4790K. Based on 180W TDP, I would expect a +8C or so coolant rise at full load, but obviously is the idle temp is in the 60s, there is another problem. Link to comment Share on other sites More sharing options...
icsim Posted July 25, 2019 Author Share Posted July 25, 2019 It actually goes to 68C right after I boot up without running any applications. Link to comment Share on other sites More sharing options...
Recommended Posts