Jump to content
Corsair Community

CMX512-3200C2 2 sticks TWINX


InkMing

Recommended Posts

  • Corsair Employees
Can you the make and model of MB you have along with the CPU speed and it’s FSB as well? In addition, please tell me the bios settings you have set for both CPU and memory and any performance settings that you may have set?
Link to comment
Share on other sites

Systems is a Shuttle ST61G4

Chip is an Intel 2.4

CPU Frequency is 200X12.0

FSB Clock Auto

VDIMM Auto

CPU Voltage Auto

 

DDR Frequency 400MHz

Memory Frequency Auto

Memory Timing Parameter Auto

CAS Latency 2.5

DRAM RAS# to CAS# Delay 3

DRAM RAS# Precharge 4

Active to Precharge Delay 8

Link to comment
Share on other sites

  • Corsair Employees

Please set the Dim Voltage to 2.75 Volts and set the timings to the tested settings Cass 2-3-3-6 and test the modules one at a time with http://www.memtest.org.

CPU Frequency is 200X12.0

FSB Clock Auto

VDIMM 2.7X Volts

CPU Voltage Auto

 

DDR Frequency 400MHz

Memory Frequency 400 MHz

Memory Timing Parameter Manual

CAS Latency 2.0

DRAM RAS# to CAS# Delay 3

DRAM RAS# Precharge 3

Active to Precharge Delay 6

Link to comment
Share on other sites

I have another system that I can take offline to test them in. I was able to set the voltage to 2.7. 2.75 is not an option.

Even under 2.7 they were throwing errors in memtest. I will try on the other system and get back to you.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...