Jump to content
Corsair Community

Glitchmob
 Share

Recommended Posts

I just recently RMA'd my second Commander Pro because it stopped working. I have posted this same question/thought to Corsair support and i'm waiting for a response. I have Noctua fans that were working fine with the commander pro till recently. I really like the commander pro as I can fine tune case performance to the application. As I haven't found anything similar in the sector.

 

NF-14 IPPC 300 pwm

My fan specs:

 

3 phase motor

max input power: 6.6W

max input current: .55A

 

As with these specs I should be able to run 3 within the threshold of the commander pro, right?

 

Also I wonder of getting the NA-FC1 fan controller from Noctua to act as middle man and send the pwm/rpm to the commander pro(if I read the features right) so I can theoretically control the fans in ICUE.

 

https://noctua.at/en/na-fc1

Link to comment
Share on other sites

The Noctua 3000 rpm industrial versions have always been difficult on various controllers, including Corsair. Make sure you do not double them up on individual C-Pro headers. That aside, there have been several reports of the same issue. I do not recommend them for the C-Pro. Interestingly, the 2000 rpm industrial version does not seem to be afflicted in the same way. It appears to be a motor and signal incompatibility.
Link to comment
Share on other sites

 Share

×
×
  • Create New...