Jump to content
Corsair Community

Icue reading from memory temp sensor


hagar_uk
 Share

Recommended Posts

I can assign my fans for a h110i to work off my temp sensors around the system. I am considering buying the expensive corsair ram fan. But can I configure it to run from the temp sensor built into the g skill memory dims I have installed. Icue is currently reading from an nvidia gfx card, as well as multiple board sensors. Being able to configure specifically for the dimms would be a huge help.
Link to comment
Share on other sites

Yes, in general, you can use iCUE to setup a Custom fan curve setting under the Performance tab and have it modeled after whatever temp sensors the iCUE software is detecting in the Dashboard.

 

However, I'm not sure if the Dominator Airflow Platinum RGB fan is compatible with iCUE? I'm assuming that is the fan you are asking about. Hopefully, another forum member can confirm compatibility. If so and your G.Skill memory sensors are currently being picked up in the iCUE Dashboard - you should be good to go with a Custom fan curve.

 

Cheers,

 

Tony

Link to comment
Share on other sites

 Share

×
×
  • Create New...