Jump to content
Corsair Community

asus rampage vi extreme + H150i


Duration
 Share

Recommended Posts

Hi all,

 

I would like to fit:

 

- asus rampage vi extreme

- h150i (top) with 3 x ml120 pro rgb

- 3 x ml120 pro rgb (front)

- 1 x ml120 pro rgb (rear)

 

into a corsair mid-tower case, ideally a 500d rgb se premium.

 

I read in this thread that somehow the motherboard fits into a 570x, but the motherboard is e-atx 30.5 x 27.7 cm, so I am not too sure what to make of it.

 

Do you think the above can fit into a 500d? If not can you please advise?

Edited by Duration
Link to comment
Share on other sites

  • Corsair Employees

Hey Duration,

 

Unfortunately, I don't think any of our current mid tower cases will fit a 360 radiator as a top mount at this time.

 

Otherwise if you put it in the front you should be fine for the 500D SE and / or 570X. Keep in mind that both these cases will only fit 2 x 120 fans up top each.

Link to comment
Share on other sites

Hi Caliente,

 

Thanks a lot for your reply. That's very good news in a way, 240 mm at the top is not such a big issue. I am more worried about not enough standoffs or the board being in the way of cable routing. Are you 100% sure the board will fit properly and that the case will be 100% functional? The rampage vi is a huge board, borderline XL-ATX. It would be awesome if somebody from QA could take a look, if you have a rampage vi or similar handy.

 

Also, any reason why E-ATX is not listed under the compatibility section of those cases?

Link to comment
Share on other sites

 Share

×
×
  • Create New...