Jump to content
Corsair Community

h75 v1


billc16
 Share

Recommended Posts

Hi can anone advise on why my h75 v1 wont fit a z390 board which uses a lga 1151 socket. The stand off screws dont seem long enough to accomodate the bracket/cooler. The only way i can get it to fit is to leave the stand off screws sticking out proud of the motherboard/back plate but then this causes the cooler bracket to bend when tightening the thumb screws. I have messaged corsair who have said are you using the correct stand offs and yes i am but i just cannot figure what i am doing wrong. Any help would be appreciated so i dont have to buy a new cooler.
Link to comment
Share on other sites

 Share

×
×
  • Create New...