wim-bart Posted November 24, 2018 Share Posted November 24, 2018 In Link I was able to set the pump speed. How can i do it in iCue? And why does iCue show a red exclamation mark in the notification area? Link to comment Share on other sites More sharing options...
c-attack Posted November 24, 2018 Share Posted November 24, 2018 Go to the Performance Tab for the cooler. Select either Quiet or Extreme from the left side. It will highlight yellow. Then click on the pump. It will also highlight yellow. A little counter-intuitive and opposite what most people expect - select device and tell it what speed to run. If you hover over the red(!), it should give more information. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.