First Time using Link & iCue software

[SGTDRE]

Hello pone and all, First post here on Corsair.

 

With this new build I'm working on, I will being using Six(6) ML120mm RGB other than the 180mm x 2 fans in a TJ11.

 

Mobo: Asus Maximus VII Performance, I looked through the user Guide / book and It seems like there are zero PWN headers other than maybe the CPU fan header that may give some level of control, but until I get the system up and running I'm unsure.

 

I o have a 5.25 bay fan pump controller but it would a bit useless for just a pump.

 

CPU Water Block: Heatkiller

Mosfet Preinstalled Block:

Chipset Block: I may or not WC

Radiator: Alphacool 360

GPU Block: None, Can't get them

EK-D5 PWM G2 Motor (12V DC PWM Pump Motor)

 

Is there any way that I could use the link or iCue software to control the pump speed, as you would the fans. I did look through the Info & Diagram Thread and was thinking that maybe the temp connections may work.

 

Any assistance would be helpful.

[DevBiker]

Based on the specs on that link (4 Pin Molex and 3 Pin Tacho Output), the pump is powered by the molex connector and only reports speed via the 3-pin output; it doesn't provide control.

However, based on this link :https://www.ekwb.com/shop/ek-d5-pwm-g2-motor-12v-dc-pwm-pump-motor (which matches the description of the pump), that pump will use almost 2A. That's more than the Commander Pro can handle.

[SGTDRE]

Based on the specs on that link (4 Pin Molex and 3 Pin Tacho Output), the pump is powered by the molex connector and only reports speed via the 3-pin output; it doesn't provide control.

However, based on this link :https://www.ekwb.com/shop/ek-d5-pwm-g2-motor-12v-dc-pwm-pump-motor (which matches the description of the pump), that pump will use almost 2A. That's more than the Commander Pro can handle.

 

I thank you, I do appreciate the assistance. EK is the one place I did not look to see the full specs, so much going through my head and trying to do three things at once.