Slugeball Posted August 7, 2018 Share Posted August 7, 2018 Hi So I am a complete scrub when it comes to computers, and I just finished building my first tower. I have a Corsair Carbide Spec-Omega. The very first thing I installed was the iCue software so that I could control the RGB on the fans and the light strip along the outside of the case. When I open the software, it detects my case, but none of the LEDs are on, not matter how much I fiddle with the settings. I'm not sure if I am doing something wrong in the software, or if I don't have something plugged in correctly into the motherboard (again, complete beginner here). The instruction manual for the case is no help as it doesn't offer many details. Again, sorry if it is such an obvious solution, but this is my first time doing something like this. Thank you Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 Hi buddy.... do you have the Spec Omega tile showing in iCue? Link to comment Share on other sites More sharing options...
Slugeball Posted August 7, 2018 Author Share Posted August 7, 2018 Yes, it does show the case. Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 ok.. click on it... then click 'Lighting Setup' on the left side of the screen,, whats showing? Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 this may help.... [ame] [/ame] Link to comment Share on other sites More sharing options...
Slugeball Posted August 7, 2018 Author Share Posted August 7, 2018 It says Lightning Channel 1, and a drop-down menu that it wont let me click on. Then there is Lightning Channel 2 with a drop-down menu that I can click on, with options to select either the RGB light strip or the fans. But clicking on those seems to do nothing. Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 watch the above video buddy.. see if that helps..... Link to comment Share on other sites More sharing options...
Slugeball Posted August 7, 2018 Author Share Posted August 7, 2018 Yeah I watched the video, and it didn't help. I see what I am suppose to do, and I did exactly what is shown there, but its just that none of the LEDs are even on. Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 so if you go into Lighting Channel 1. you see the cases LED's?.. and you have added a lighting effect?.. and then selected the LED's? Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 firstly.. check the Sata Power Connection to the Lighting node Pro in your case...then check that the cases lighting is plugged into LED Channel 1 of the Node Pro.. Link to comment Share on other sites More sharing options...
Slugeball Posted August 7, 2018 Author Share Posted August 7, 2018 Ah I was a able to figure it out. It was plugged into the wrong channel. Thanks for your help, and again, sorry for my stupidity. This is all very new for me :/ Link to comment Share on other sites More sharing options...
Zotty Posted August 7, 2018 Share Posted August 7, 2018 No worries dude... might be worth reading the below thread for future reference.. you will buy more! lol http://forum.corsair.com/v3/showthread.php?t=173880 No need to be sorry dude... very little instructions supplied ;) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.