Jump to content
Corsair Community

Newbie here and Need help!


Rain1983
 Share

Recommended Posts

You are correct about the extra RGB Fan LED Hub and then you can connect the 2nd hub to the 2nd lighting port in the commander pro.

 

By control, you mean the fan speed?

You can put it into a PWM header on your motherboard to control the last fan. Or you can use a pwm splitter on the commander pro (I've read eventhough it is not supported officially, that it does work), so a pwm splitter from 1 port two 2 ports. It is basically just an adapter which make two fans act as one fan, but you can still control both (they will get same fan speed). You can only see on fan though.

 

Not sure if you can follow me, else feel free to reply and I will clarify :)

Link to comment
Share on other sites

You are correct about the extra RGB Fan LED Hub and then you can connect the 2nd hub to the 2nd lighting port in the commander pro.

 

By control, you mean the fan speed?

You can put it into a PWM header on your motherboard to control the last fan. Or you can use a pwm splitter on the commander pro (I've read eventhough it is not supported officially, that it does work), so a pwm splitter from 1 port two 2 ports. It is basically just an adapter which make two fans act as one fan, but you can still control both (they will get same fan speed). You can only see on fan though.

 

Not sure if you can follow me, else feel free to reply and I will clarify :)

 

 

Ah! A pwm splitter! Hopefully this will work! Thanks for your advise!

Link to comment
Share on other sites

 Share

×
×
  • Create New...