Jump to content
Corsair Community

Spec-omega RGB case is too small.


umiumi223
 Share

Recommended Posts

https://imgur.com/a/QOtoALa

 

i think umm.. corsair case developer , I dont know how developed from the development stage.

 

back side is too too too x3 small so i cannot close side door.

 

i m using extend SATA x2 VGA x2 but this case ..like using many of lines are too difficult build this case.

 

anyone give me tips how to close this case

Edited by umiumi223
Link to comment
Share on other sites

https://imgur.com/a/QOtoALa

 

i think umm.. corsair case developer , I dont know how developed from the development stage.

 

back side is too too too x3 small so i cannot close side door.

 

i m using extend SATA x2 VGA x2 but this case ..like using many of lines are too difficult build this case.

 

anyone give me tips how to close this case

 

My OCD, it burns!!!! :)

 

Try removing some of the unused items like SSD mounts. This might make more room for some routing. I take out any item I am not using. I would run CPU power and rear/top fans down the right side and send the MB Power and other cables up the left side. You might have to play around with running some of the longer cables as one group and some of the shorter cable as another group both on the left side. It looks like a pretty small area and without a dedicated channel for cable management, it looks like you might have to do a couple different routes to get where you need to. You also might have to sacrifice your cable extensions or go with ones that plug into PSU, if you have modular. The less room you have the more creative you have to be.

 

I do agree there could be a little more room back there.

 

Post more stats in your system specs.

Link to comment
Share on other sites

 Share

×
×
  • Create New...