Jump to content
Corsair Community

780t , AIO fit


segasage
 Share

Recommended Posts

  • Corsair Employees

Hello Segasage,

 

I don't believe there should be any fitment issue with the H150i Pro in the front of the 780T using the three 120mm fan mounts, but you would need to remove the HDD bays in order to use it this way.

Link to comment
Share on other sites

You should be able to fit in the top as well and others have. There might be some needed massaging in certain areas, but I don't have the case to comment further. See the threads below with some lateral information.

 

http://forum.corsair.com/v3/showthread.php?t=177524&highlight=H150i+780T

 

And general front 120 placement:

http://forum.corsair.com/v3/showthread.php?t=177552

Link to comment
Share on other sites

  • Corsair Employees
You should be able to fit in the top as well and others have. There might be some needed massaging in certain areas, but I don't have the case to comment further. See the threads below with some lateral information.

 

http://forum.corsair.com/v3/showthread.php?t=177524&highlight=H150i+780T

 

And general front 120 placement:

http://forum.corsair.com/v3/showthread.php?t=177552

 

Great info! One quick note about top fitment though. If you have anything in the ODD bays or are going for a push/pull set up there could be interference with other parts. Due to the extra width added by a push/pull set up, it's possible that it could interfere with DRAM or VRM heatsinks depending on their height and location. This is really dependent on motherboard, though.

Link to comment
Share on other sites

I have the 780T and also the H150i and it fits perfectly in my case.

 

- I'm using a push/pull configuration.

- There are 2 ODD bays available for the 780T and this will take up one ODD bay, so you will only be able to use one which is the bottom one.

- I have it installed at the top.

- I tried installing it at the front and I was successful in that. However, The 780T's airflow states that air should be coming in from the front and out the top.

- My temperatures increased when I installed it at the front so I installed it back at the top and the temperatures are back to normal.

- You don't need a push/pull configuration. 3 fans will do, with my push/pull configuration I'm reducing the temperatures by 2 degrees Celsius.

 

Images of my setup below:

 

Main top (Push section): https://imgur.com/a/ciem6Tm

Right side (ODD bays): https://imgur.com/a/3DD3k6h

Top (Pull section): https://imgur.com/a/L46i0PS

Edited by ViperAttack
Link to comment
Share on other sites

 Share

×
×
  • Create New...