Jump to content
Corsair Community

Commander Pro USB


gamingking3
 Share

Recommended Posts

hey on my commander pro i can't get my NODE PRO to work when its hook into my CLCP USB not sure if i am doing anything wrong i have my CLCP hook into my front USB hub and i have my RGB HUB connect to the commander pro LED for the RGB fans n the 4 strips are hook up to the other LED on the clcp. This is the second CP cause i taught the first one had issues also whats to do from here?
Link to comment
Share on other sites

There have been issues with AMD platforms and the CoPro's USB hub but these should be resolved with the most recent firmware.

Can you make sure that you have the latest firmware for the CoPro?

Also, make sure that Legacy USB support and XHCI Handoff are enabled and that you have the latest drivers for your chipset.

Link to comment
Share on other sites

Ok i have try all that i had too and still nothing i try plugging it in them unplugging it and while it was unplug push the reset pin in and while holding the pin in plug the SATA cable back in the light on the CLCP flashes couple of times but when i hook the NP or the other CLCP into it nothing yet
Link to comment
Share on other sites

 Share

×
×
  • Create New...