Nightscream Posted February 9, 2005 Share Posted February 9, 2005 Allright, I know that there were a number of posts here concerning K8N motherboards and CMX mem modules, and I read them all ;) However, none were about the nForce4 SLI Diamond version ( I think ) . So, I'll ask again :) I have bought myself a MSI K8N Diamond and 2 modules CMX1024-3200 ( with a small sticker that says XMS3200v3.1 ) ... I would like to run them in dual-channel mode and in PC3200 ( of course ;) ) Will it work as standard ( I do not want to overclock ) or will I have to set manual settings? If yes, what settings are recommended? Any help would be greatly appreciated :) Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted February 9, 2005 Corsair Employee Share Posted February 9, 2005 As long as they are exactly the same part# and revision you should have no problems, just load setup defaults and then set the Dim Voltage to 2.7 Volts is all I would do, and you should good to go! Link to comment Share on other sites More sharing options...
Nightscream Posted February 10, 2005 Author Share Posted February 10, 2005 thanks for the reply ! i'll let you know if all runs well :) Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted February 10, 2005 Corsair Employee Share Posted February 10, 2005 Please do! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.