howardpm Posted March 15, 2018 Share Posted March 15, 2018 I just rebuilt my new system, reusing my 780T case and the side panel (where the wires are hidden) won't fully close. there is probably 1/2 inch on the top front area which does't sit flush, I can push it in but it just bounces back. I feel like I had this issue when I built my original system a couple years back. Anyways I took the glass panel from the other side and put it on the cable side and it sits flush perfectly, so I don't think the cables are casing issues. I then took the closed side panel and put it on the window size and it seemed to sit flush. Is it possible the side panel is warped? But if that is the case why would it sit fine on the opposite side? Link to comment Share on other sites More sharing options...
HyperActive78 Posted April 8, 2018 Share Posted April 8, 2018 I had the same issue for the longest time, then one day I happen to have that side panel off and noticed one of the tabs/slots at the bottom of the door was bent upwards. I straightened it out and panel has been flush ever since. Link to comment Share on other sites More sharing options...
Recommended Posts