Jump to content
Corsair Community

Can't control rgb and fans with commander pro and lighting node pro


Tj-willock
 Share

Recommended Posts

I have set up the commander pro and lighting node pro with 4 ll120 rgb fans. And one rgb led expansion pack.(4 led strips) i have downloaded and updated the corsair link software. I cannot adjust the colors on the any of the leds on fan or strips. I have drawn out a diagram of my set up. Any help would be greatly appreciated.

15176991135571669704074.thumb.jpg.59cb6e8b1b933a772b91d5074a4ea29c.jpg

Link to comment
Share on other sites

Can you post a screen shot of your Link configuration?

And you added the fans correctly in link?

 

Note: with a Commander Pro (CoPro), 4 fans and 4 strips, you won't need the Lighting Node Pro (NoPro). The CoPro has all of the functionality of the NoPro ... plus some.

Link to comment
Share on other sites

Have you manually added the fans in Link so that the the application can recognize them? If you haven’t that’s probably the issue right there.

 

yes i have added the 3 fans at link. only the 1st fan on port 1 can be controlled by corsair Link, rest doesn't have any lights. sometime when i put my PC to sleep and turn on again. The 1st fan is always normal but rest 2 it shows light. sometimes White, sometime red with blue. very strange.

Link to comment
Share on other sites

 Share

×
×
  • Create New...