Jump to content
Corsair Community

epox 8RDA3+ and CORSAIR XMS PC3200 512MB CL 2


thebungee

Recommended Posts

Hey freaks, :eyebuldge i own one piece of CORSAIR XMS PC3200 512MB CL 2 and the epox 8rda3+ Mainboard.(nforce Ultra 400) I like to know if i can buy me a second Module of this Ram and use it in dual channel mode. Or must i upgrade to TwinX Modules ? I´m not a performance freak so i only won´t to know if the board will boot with this two "normal" modules ? Thx Kai Hamburg Germany
Link to comment
Share on other sites

  • 3 months later...
  • Corsair Employees
I would suggest testing the memory with another system if possible and yes a Twinx C2 set should be able to run at DDR400 at Cass 2-3-3-6 as long as your MB and CPU will support it. I would try the modules one at a time and lets make sure you don't have a bad or weak module.
Link to comment
Share on other sites

Thanks! I will do it next week, then post here. when i try 2 cas latency, have errors on memtest86, only in 2.5 cas was right 2-3-2-6, 2-3-3-8, 2-2-2-7, 2-2-2-11, 2-2-2-6 ERROR 2.5-2-2-6. 2.5-3-3-8 OK vdimm 2.7 200x9.5 vcore default vdd 1.6 +5: 4.972 V +12: 12.160 V sys: epox 8rda3+ rev. 1.x last. bios (8RD33A17.BIN) heatsinks on mosfests, ZM-NB32J on nb, hsnk + delta 50mm on sb Barton 2500 w/Slk900A + Tornado 80mm Corsair Twinx 3200CL2 256x2, 1+3 banks Antec Truecontrol 550w
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...