Jump to content
Corsair Community

Liquid-damage: LEDs turn default then off


Teyserback
 Share

Recommended Posts

Hello everyone, I just accidently spilled juice over my keyboard and it apparently got into the actual board. The keypresses still work and are recognized correctly, but after trying my best to dry it without unscrewing it and drying it from inside, as soon as I plug it in the default LED layout appears (everything red except wasd and arrow keys) on every key, so LEDs themselves seem to work fine. Yet after about 1-2 seconds, when the utility engine profile would load, the lights stay turned off. Has anyone had this specific problem before or does anyone have any neat tips or tricks to try and dry it as good as possible without opening the case of the keyboard?

 

Thanks in advance!

Link to comment
Share on other sites

Try taking it to the store where you bought it try not to mention that you had water damage, if you get lucky they will just replace it without questions and get you a new one, but i suggest not to do that, but it works if you get lucky
Link to comment
Share on other sites

 Share

×
×
  • Create New...