Jump to content
Corsair Community

Commander Pro Firmware 0.3.153 problem


Recommended Posts

This was a mandated change to ensure operation of the new LL fans. See this thread below.




Unless you are using LL fans, you don't need FW 0.31. I am in the same boat on a Commander Pro and I need to work without Link running all the time. See the sticky at the top of this section on how to roll back. I also prefer Link 4.8.3 and you may wish to go back to that if you are using the temp probes.



Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...