Jump to content
Corsair Community

Surface Calibration resets on reboot


Golden_Pants
 Share

Recommended Posts

Hey there ^^

I'm sorry if a thread like this already exists but I'm experiencing a problem with my Corsair Glaive RGB and the Utility Engine.

First of all, if I don't calibrate the mouse to my table through the software, the sensor is way to sensitive, it even reacts when I slightly lift up the Glaive.

So to fix that, I attemptet to use the Surface Calibration function in the CUE. It works, the problem is gone and the sensor works perfectly fine.

However, everytime I reboot my computer, the Surface Calibration seems to be completely 'gone' as the sensor is oversensitive again. If I calibrate again, it works completely fine.

EDIT: Nevermind, I fixed it ^^ I updated the firmware and did the surface calibration a few times and saved it to the hardware profile on the Glaive.

Thanks anyways^^

Edited by Golden_Pants
Link to comment
Share on other sites

 Share

×
×
  • Create New...